I'm printing a 11" tall horn. This picture is taken at about 8-9in high, and printing is still going on.
If my calculation is correct, the extruder (top part, near the bulky cable) will hit the spool holder in the next 2-3 hours. Has anyone printed something in gmax to its max (or almost max) before?
I hesitated to move the spool all the way to the left/right because the pulling action will be going to the side, and may destabilize the spool.
Advise?
Thank you.
If my calculation is correct, the extruder (top part, near the bulky cable) will hit the spool holder in the next 2-3 hours. Has anyone printed something in gmax to its max (or almost max) before?
I hesitated to move the spool all the way to the left/right because the pulling action will be going to the side, and may destabilize the spool.
Advise?
Thank you.