Good after noon folks,
Though I do not know if that is considered to be an acceptable term “folks”, in NY? Hope all is well.
As for me, not so much, around midnight, Albuquerque time I gave up, though I did not allow me to
sleep too much as I could not quit thinking about what the problem might be.
Obviously, it is going to be something very simple because you folks spent two hours testing the
machine and I am just over looking something that is keeping me from completing my first print.
In order to insure we both share the same orientation, I shall refer to the Top as N (north), the Bottom
as S (south) Left as W (west) & Right as E (east).
So I begin as instructions suggest, up to inserting the card and choosing to print the selected file. The
Extruder assembly moves to the upper left (north-west) corner. Then it moves to the center of the print-
board. It hovers approximately 1/4” above the board while letting out filament. It then travels about 3”
down (south) and is now about a business card above the board, it prints a very thin circle, then makes
a couple of circles without letting out any filament, though it is making some other type of melody type
of noise it then goes to the far left (west) edge of the print board and stops.
I have tried repeatedly with two different 3D models and both of them do the same thing. I would be
grateful for any suggestion that you may be able to provide.
Thank You.
Lee@TriVention.com
Though I do not know if that is considered to be an acceptable term “folks”, in NY? Hope all is well.
As for me, not so much, around midnight, Albuquerque time I gave up, though I did not allow me to
sleep too much as I could not quit thinking about what the problem might be.
Obviously, it is going to be something very simple because you folks spent two hours testing the
machine and I am just over looking something that is keeping me from completing my first print.
In order to insure we both share the same orientation, I shall refer to the Top as N (north), the Bottom
as S (south) Left as W (west) & Right as E (east).
So I begin as instructions suggest, up to inserting the card and choosing to print the selected file. The
Extruder assembly moves to the upper left (north-west) corner. Then it moves to the center of the print-
board. It hovers approximately 1/4” above the board while letting out filament. It then travels about 3”
down (south) and is now about a business card above the board, it prints a very thin circle, then makes
a couple of circles without letting out any filament, though it is making some other type of melody type
of noise it then goes to the far left (west) edge of the print board and stops.
I have tried repeatedly with two different 3D models and both of them do the same thing. I would be
grateful for any suggestion that you may be able to provide.
Thank You.
Lee@TriVention.com