Recent content by Primpnpet

j-Head....and I have made the changes to the code. Still running into issues with the code not saving. After a few prints or when I turn off the power, once back on I have the same original issue with the z-Axis.

After re-uploading firmware several times and following the steps above I go the setting to save and hold. Now I'm getting the following error with every print after the first pass. I tried to export new g-code files with no luck.

So this worked for a while but once I power off the unit I have the same issue again. Tried re-uploading the software and following your instructions but I continue to have the same issue. I notice it when using "Auto Home" function the z-axis moves upward. If I attempt a print it moves up and...

Just upgraded to Cura 3.2.1 and Marlin 1.1.8. on my Gmax 1.5+ single. I am now having a issue with the Z-Axis crashing against the top rail and can only stop it using the off button. Also tried to run the initial setup file and its attempting to print 1 inch off the bed, and wont allow...