Hi,
I've got the potentiometers set properly and printed some things that came out great, using the by Gcreate supplied Rs200-GH from Colorfabb (at least, that's on the spool), using the Zen Toolworks ABS - Generic settings (t=230-235) with the fan completely off (to prevent disforming) in Slic3r for filament settings. Works great, sticks properly but my roll is about gone.
So I ordered some ColorFabb PLA/PHA filament (on the box: processing temp 190-210), used the ColorFabb PLA (generic) as Slic3r Filament settings, adjusted the first layer to 197 (tried some values between 194 and 197) but the stuff just won't stick to the acrylic plate. Sanded it and everything.
What am I doing wrong / what can I try?
regards
Jeroen
I've got the potentiometers set properly and printed some things that came out great, using the by Gcreate supplied Rs200-GH from Colorfabb (at least, that's on the spool), using the Zen Toolworks ABS - Generic settings (t=230-235) with the fan completely off (to prevent disforming) in Slic3r for filament settings. Works great, sticks properly but my roll is about gone.
So I ordered some ColorFabb PLA/PHA filament (on the box: processing temp 190-210), used the ColorFabb PLA (generic) as Slic3r Filament settings, adjusted the first layer to 197 (tried some values between 194 and 197) but the stuff just won't stick to the acrylic plate. Sanded it and everything.
What am I doing wrong / what can I try?
regards
Jeroen