New to 3D printing, but I have a fair amount of 3D and mechanical experience. My first test prints seemed fine, but I have come up on an issue I'm not sure how to handle. When printing I am getting a Y axis drag, that seems to be caused by the printer riding hard on the layers already put down. It is either the Z isn't coming up enough on each run or more likely from my observations that the printer is laying down to much material and pushing it into peaks on either side of the head. I can see and hear the thump as it comes back on the next pass. It is worst on the honey comb as it catches as the head travels. Any thoughts on how I might tackle troubleshooting this issue.
FD
FD
Attachments
-
43.3 KB Views: 1,602
-
23 KB Views: 1,602