Printer is not feeding and stopping extrusion during print

So as the title says, I have a printer (gMax 2) that is just not feeding continuously while printing. Really needs to be babysat which is a huge waste of my time. It'll print for say, 45 layers and then suddenly its just going through the motions, not feeding. This is with any filament I try, it just stops feeding. I've cold pulled the hot end, that came out clean. I'm at a loss.

Any help that can be offered urgently would be appreciated.
I am having the same issue. Did you ever get a resolution?

My issue, Gmax 2pro. The extruder motor stops mid print. It’s not jammed, Motor is stopped completely, will not respond to manual extruder inputs until I reset the printer (turn off and on).

The motor is not getting hot, the driver is not getting hot. I have replaced the driver. Increased the driver amps to 1200 ma and decreased to 800ma. Reinstalled the firmware and screen firmware. Using latest Gcreate firmware.

What do I try next? I will try swapping the stepper, also adding an independent ground to the stepper.

What say you? D