Hey, sorry about the late response, I was troubleshooting back and forth. I tightened up the Y belt, and on the contrary, the power for the Y motor was not enough, and the less that I made it, the more error it printed. When I turned it up slowly, it started calibrating and printing in place. I also fine tuned the Z axis calibration screw because it was too close, and it was laying down the filament too thick, thus smudging out the detail seen in the wire clips (I used the clips for my first files because they are intricate, so I figured if I can get them printed, I can get anything printed.) Here is a pic of my first successful print, with the stock clips as reference. Happy happy happy.