Recent content by Casper

I’m having this issue now, on our 1.5XT+. The main extruder stepper motor started clicking instead of turning, wouldn’t feed filament. I adjusted the driver, but that didn’t help, so I swapped in the motor from the secondary extruder head. That worked OK for a bit, but that motor is now failing...

Thanks again Shaqfoo for your help. I finally got around to setting this up and actually was able to get it working.

I have not had a chance to finish setting up my auto level yet but looking at the images again it seems that in this config I am no longer using the default 'Z' end stop that is mounted on the vertical aluminum extrusion and instead utilizing only the probe mounted to my servo arm. So before I...

Thank you very much for the pictures and info, it is greatley appreciated. I will definatley try this out today. I guess one of my issues was that I attempted to use all 3 pins on the switch and from your explanation I only need two.

PLEASE HELP I installed the firmware provided by ShaqFoo and all is good on that end. I also have mounts for my servo and micro switch for the Z probe used in auto leveling. My issue is how to wire up and configure the firmware for the micro switch. I was following these videos...

This thread saved me many headaches. My first issue was updating the firmware which I attempted myself awhile back prior to finding shaqFoo's post. After digging for awhile I realized that I needed to use and older version of Arduino to compile it. However shaq I greatly appreciate your extra...

I contacted tech support for Simplify3D about the configuration files for our printers and they were awesome enough to provide me them. So far I love Simplify3D even though the price tag was a bit tough at first it has proven to be a good investment.