gmax 1.5

I have upgraded from 1.5 to 1.5+ duel extruder with TMC 2130 drivers on the X and Y steppers. I have been having problems with the control bored (like blue smoke) and I was wandering if the original 1.5 power supply is not sufficient enough for the Gmax 1.5+ system.

Hi Everyone, In view of the corona 3D print requests -- I'm looking to upgrade my very aged (original Gmax 1.5 with LCD display) to do some printing for the Local hospital needed items, like ear protectors for the mask straps. 1. Is it possible/practical to upgrade it to the full display? --...

File includes all 3d parts including single and dual extruder. Slicer settings vary per part. Experiment and come up with your favorite combination but typically use 4 walls and 65% infill. License: Creative Commons - Attribution - Share Alike. http://creativecommons.org/licenses/by-sa/3.0/

Modified marlin firmware used on the gMax 1.5 series of printers. This is the original firmware that shipped with the printer. The firmware is used with DUAL Extruder printers with G3D (Blue) electronics and the 4x20 original LCD display. Firmware does NOT include auto bed leveling. Please...

Modified marlin firmware used on the gMax 1.5 series of printers. This is the original firmware that shipped with the printer. The firmware is used with SINGLE Extruder printers with G3D (Blue) electronics and the 4x20 original LCD display. Firmware does NOT include auto bed leveling. Please...

Build manual for the gMax 1.5 3D printer. Please note this is the final release of this document and no further updates will be made.

This unique spool holder will fit all gMax versions. If you find your filament brackets are a bit too tight, this new spool holder has much less friction and will allow your spools to unwind freely since it runs on a 608 bearing. It also includes a filament director arm with a ball joint...