Hi, I am using a 1.5XT+ with firmware 1.19Beta and Cura 3.6. I have had no issues previously with printing smaller projects. My current project was supposed to print in approximately 5 days. First attempt the Printer stopped printing after about 8 hours. The control unit was locked up and nothining I could do to recover and once you power on reset I decided to start over. This time I was just under 3 days into the print and on my second spool of PLA and the same thing happened again. One thing I did do both times was leave the Babystep control on. Not sure that is the culpren