Hey everyone, pretty new to the forum but I've had my gmax for about 6 months now. Overall i'm very happy with it but i'm having some issues recently that have me trying to find a solution:
currently i'm having an issue with the "auto-home" function on the printer. it has worked in the past but I recently had a very catastrophic failed print and since then I haven't had much luck on getting any prints to work right. but here's the issue:
when I give the command auto-home from the printer itself, it'll home the x axis, then the y axis, but rather than going to the center, it attempts to home the z-axis in that corner. and when it does come in contact with the bed, it pushes straight through. I have turned the machine off to prevent any damage and unfortunately since this started to show I haven't been able to correct it. Any thoughts?
gmax 1.5xt+ dual extruder, I have been using Octopi to control it normally. Thanks!
currently i'm having an issue with the "auto-home" function on the printer. it has worked in the past but I recently had a very catastrophic failed print and since then I haven't had much luck on getting any prints to work right. but here's the issue:
when I give the command auto-home from the printer itself, it'll home the x axis, then the y axis, but rather than going to the center, it attempts to home the z-axis in that corner. and when it does come in contact with the bed, it pushes straight through. I have turned the machine off to prevent any damage and unfortunately since this started to show I haven't been able to correct it. Any thoughts?
gmax 1.5xt+ dual extruder, I have been using Octopi to control it normally. Thanks!